Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.

Works Best On:
Balsa Wood
Ceramics

Works Good On:
Soft Wood
Fiberglass
Hard Plastics
Water-Resistant
CA Hinges

Directions:
Unscrew top from nozzle. For finer applications, use the extender tip. Insta-Cure™ CA is used to bond tight fitting parts. Hold the parts together (sometimes using masking tape), then apply the Insta-Cure™ along the joints. The CA will penetrate deep into the joints. Bonding will occur in 1-3 seconds. Excess cured CA can be removed from surfaces like ceramics by rubbing with a paper towel soaked in Un-Cure™. Full strength is reached in two hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220º F. Soak extender tip in acetone for cleaning.

SKU BSI103
Barcode # 0707336103008
Brand Bob Smith Industries
Shipping Weight 0.3000kg
Shipping Width 0.080m
Shipping Height 0.080m
Shipping Length 0.100m
Shipping Cubic 0.000640000m3

Be The First To Review This Product!

Help other RCMA Model & Hobby Shop users shop smarter by writing reviews for products you have purchased.

Write a product review

Related products

More From This Category